SMF Support > YaBB/YaBB SE

[SMF Converter] YaBB SE 1.5.4

<< < (2/27) > >>

Cyberclone:
 :D :D Now it works wonderfull, thanks for your support  :-*


--- Quote ---Conversion Complete
Congratulations, the conversion has completed successfully. If you have or had any problems with this converter, or need help using SMF, please feel free to look to us for support.
--- End quote ---

Chuck:
Hi,  I have been trying to convert my yabbse forum to SMF using the files in this thread.  It works fine until after it converts the post and then it gets an Internal Sever Error.

Any ideas?

Thanks.

Chris Cromer:
I don't know why but after using this converter random members have an ID_GROUP setting of 11... even though that group does not exist. This caused me alot of headaches since the members with that group id could not see anything. It was funny that when they logged in the boards where gone, but when they logged back out they came back. ;D

I already fixed it in my conversion since it was just a matter of running an update query, but thought I would report it for you to look into.

JayBachatero:

--- Quote from: Chuck on February 14, 2007, 12:52:59 AM ---Hi,  I have been trying to convert my yabbse forum to SMF using the files in this thread.  It works fine until after it converts the post and then it gets an Internal Sever Error.

Any ideas?

Thanks.

--- End quote ---
Does the post conversion make any process at all or once it gets there it gets the error?


--- Quote from: Chris Cromer on February 15, 2007, 06:44:37 AM ---I don't know why but after using this converter random members have an ID_GROUP setting of 11... even though that group does not exist. This caused me alot of headaches since the members with that group id could not see anything. It was funny that when they logged in the boards where gone, but when they logged back out they came back. ;D

I already fixed it in my conversion since it was just a matter of running an update query, but thought I would report it for you to look into.

--- End quote ---
Chris that is weird.  Was it a primary or secondary group?  If you look at this part it shows you that it gets the correct group.

--- Code: --- CASE
WHEN mem.memberGroup = 'Administrator' THEN 1
WHEN mem.memberGroup = 'Global Moderator' THEN 2
WHEN mg.ID_GROUP = 8 THEN 2
WHEN mg.ID_GROUP = 1 THEN 1
WHEN mg.ID_GROUP > 8 THEN mg.ID_GROUP
ELSE 0
END AS ID_GROUP

--- End code ---

Chuck:
Yes, all the post are converted successfully.. When it says converting priveat messages, or after that, I get the internal sever error.  When I look in the datatbase it appears that the pm's have been converted-at least there is the same amount in the new table.  

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version