General Community > Scripting Help

how to use mail() script without writing the sender email address

<< < (2/2)

Wezz6400:
What I mean is that if I send an e-mail with lot's of addresses in the BCC field with some hotmail addresses among them and in the to field I fill in one other address (you're right there needs to be valid one) then the e-mail is going to the junkmail folder of the hotmail users. My guess is that that is because in the to field the address of the receiver is not listed.

I agree with you that hotmail stinks by the way, I just use it for sites where I need to fill in an e-mailaddress but I don't care what is send to that address.

Haase:

--- Quote from: Wezz6400 on August 22, 2003, 06:33:53 PM ---I agree with you that hotmail stinks by the way, I just use it for sites where I need to fill in an e-mailaddress but I don't care what is send to that address.

--- End quote ---

exactly...  what's beautiful about hotmail is that if you don't use your account in a specified amount of time, they deactivate it and then delete all your messages.  So you never have to worry about cleaning it out.  Just activate it every time you need to register something you don't really care about, then forget about it until you need it again.   ;D

Navigation

[0] Message Index

[*] Previous page