Simple Machines Community Forum

SMF Support => SMF 1.1.x Support => Topic started by: Siirist on May 26, 2009, 12:22:28 AM

Title: Unable to go into any profile
Post by: Siirist on May 26, 2009, 12:22:28 AM
Hello,

Which version of SMF you're using -

Just did a manual upGRADE to ver 1.1.9 yesterday (Sunday May 24, 2009)


A link to your forum -

http://www.asanctuary.net/forum/index.php (//http://)
(yes, after the upgrade I deleted the upgrade file thingy)


Any errors from your error log that may be related (please remove paths and IP addresses - only the filename, line number and error message are needed) -

Parse error: syntax error, unexpected T_STRING in ./Sources/Profile.php on line 444


A detailed description of the problem -
No one (including Admins) cannot get into their own or anyone else's profile without getting a blank page that has the above error listed.

n3rve sent me this -
Quote
Download notepad++
http://filehippo.com/download_notepad/

It will number every line
Please, don't PM for support next time, use the support boards

-[n3rve]
but I was unable to get the program to download.

So that is why I am here.  I have created a test account in anticipation that someone will want to log in.  Okay, I think that accurately describes the problem.

As I have downloaded and installed Total Commander as a FTP program, however, I am unable to get the program to connect to my host.  Thusly, I have copied and pasted the contents of Profile.php into MSWordPad and saved it as a txt.  For your convenience, you will find it attached.

I wish to thank all that reply in advance for doing so.


Be Well,
Cloud Walker
Title: Re: Unable to go into any profile
Post by: Antechinus on May 26, 2009, 12:55:52 AM
Try the attached file.

For downloading Notepad++ I use this link: http://sourceforge.net/project/downloading.php?group_id=95717&filename=npp.5.4.Installer.exe  ;)
Title: Re: Unable to go into any profile
Post by: Antechinus on May 26, 2009, 04:44:01 AM
:D Glad you're running again. It wasn't too bad. Somehow one chunk of code had got mixed up but I just cross-checked it against a clean 1.1.9 file and copy/pasted to suit.