Simple Machines Community Forum

SMF Support => SMF 2.0.x Support => Topic started by: Andres08 on January 09, 2018, 06:46:13 PM

Title: Update failed
Post by: Andres08 on January 09, 2018, 06:46:13 PM
I am not sure to continue or not with update from 2.0.14.  Any sugestion?

Andres
Title: Re: Update failed
Post by: Andres08 on January 09, 2018, 06:48:37 PM
Rest of screenshot I posting here.

Title: Re: Update failed
Post by: Arantor on January 09, 2018, 06:55:36 PM
Let me guess, you have Stop Spammer installed? Check out the mod's dedicated thread to see how to install it alongside the changes in 2.0.15.
Title: Re: Update failed
Post by: Andres08 on January 09, 2018, 06:58:34 PM
Let me guess, you have Stop Spammer installed? Check out the mod's dedicated thread to see how to install it alongside the changes in 2.0.15.

Yes very true. Stop spamer is installed and it is hard to register forum except human.  Should I uninstall stop spammer first and than continue with update?
Title: Re: Update failed
Post by: Kindred on January 09, 2018, 07:01:23 PM
did you read the mod support thread for Stop Spammer?  The instructions are listed there.
Title: Re: Update failed
Post by: Andres08 on January 09, 2018, 07:05:23 PM
did you read the mod support thread for Stop Spammer?  The instructions are listed there.

Thank you.  If I read it was it around 5 years ago. So nothing about it is in fresh memory. Will find thread about Stop Spammer.

Andres
Title: Re: Update failed
Post by: Aleksi "Lex" Kilpinen on January 10, 2018, 04:17:55 AM
You can find the topic here, Stop Spammer (https://www.simplemachines.org/community/index.php?topic=283309.0)
Title: Re: Update failed
Post by: Andres08 on January 10, 2018, 09:00:05 PM
You can find the topic here, Stop Spammer (https://www.simplemachines.org/community/index.php?topic=283309.0)

Thank you Aleksi for this. I already uninstaled Stop spammer  and upgrade smf to newest version.  Reading now link about Stop Spammer, but it looks confusing and also not everybody  have skills for hard coding.  I know it is not difficult but it can be hard to find right place to insert some code.   Thanks again

Andres
Title: Re: Update failed
Post by: Aleksi "Lex" Kilpinen on January 11, 2018, 05:44:51 AM
See this post, and the one right after it by Kindred.
https://www.simplemachines.org/community/index.php?topic=283309.msg3950394#msg3950394