Forum dead thru Mambo

[tutankhamen]

I have integrated SMF with Mambo.. Just one problem: the forum acts weird when accessed through Mambo.
Ok, so the new shared login form works when I login from my Mambo site. And if I then go to the forum, yes, I'm still logged in, so the bridge-thingey seems to work. BUT the problem is that when I try to post something or change the settings, NOTHING happens! I receive no error messages, nothing just happens. If I change something and click save, it goes back to the same page but doesn't save the settings. Or if I try to post it just goes back to the forum home page but never posts the message.
Also, if I try to login from the forum, same problem: it doesn't log in ("Welcome, Guest. Please login or register."), just goes back to the main page like nothing happened.

Everything works just fine if I go directly to the forum, not thru Mambo. But there's no point in doing that 'cos then the forum doesn't look integrated (though all the same usernames and passwords work).

What is going on?

(BTW: Mambo 4.5.2, SMF 1.0.2, MOS_SMF Bridge V3.0)

[Kindred]

1st, please check out the smf-mambo forum here under portal development. Most of yuor questions have actually been answered a couple dozen times.

2nd, you should be using bridge v3.02

3rd, do you have SEO on?

4th, you need to modify the [welcome_guest] text string in index.english.php

5th, you need to install the mambo.tar.gz package in the smf package manager.

I'm sure there is a 6, 7 and 8...   but you get the point, (I hope)

[tutankhamen]

1. I did check the forum, couldn't find a solution. My fault though, I'm sure it's been answered but like so many other support forums, this is a mess.
    All over the place.
   "Most of yuor questions" -> I only have one. Sorry, I don't want to sound rude but I'm stuck!

2. I am using 3.02. Sorry again, my mistake.

3. Yes, I had SEO on and now that I turned it off, everything works!!

4. I didn't ask how to change that text...

5. It's installed, I followed these instructions: http://www.simplemachines.org/community/index.php?topic=25718.0

So problem solved, thank you!